Beckett Oil Burner Repair - How to Replace the Ignition Transformer

Your oil burner will not light up and by checkingthe wires going to the transformer. Remember
the transformer you find out that it is not makingwhere these wires go so that you can reconnect
the spark needed to light the burner. Changing thisthem to the same spot.
part on is not difficult. I will give you a fewFasten the new transformer in place using the
pointers on how this can be done easily.two screws and connect the wires to the proper
To check you ignition transformer quickly, justplaces. Turn the power back on and try to fire
loosen the screws that hold it down and flip thethe burner. The reset button on the protectorelay
little tabs back. After pushing the reset buttonmay need to be pushed again. If the burner does
wait for the motor to start. Once the motornot light then you may have other problems also.
starts, pull up on the transformer a bit and listenYou will need to continue to troubleshoot the
for the spark to jump to the electrodes. Thisproblem or call professional help.
spark is normally very hot and will jump a gap ofIt is not uncommon for oil burner problems to
at least ¼". If you have a lazy yellowcome in bunches and for more than one part to
orange spark instead of a bright blue/white hotfail at once. Do not be discouraged if there are
spark or if there is no spark at all then you needmultiple problems. This is very normal with oil
to replace the transformer.burners. Have patience and methodically check
To change the transformer turn off the power toeach component and replace as necessary.
the burner, and flip the transformer all the wayOil burner repair can be very challenging but there
open. There are two screws that hold the hingeare many things that you can do if you have
at the back of the transformer. Remove thesome mechanical knowledge. Have fun and good
protectorelay from the junction box and unhookluck!