How to Change Your Gas Furnace Igniter

You have run all the tests and they all point tofurnace before you attempt to remove the
your igniter being bad in your gas furnace.igniter. It runs on 110V power and will give you a
Your purge blower runs, the power comes on togood jolt if you touch it with power going to it.
the igniter, but you get no glow from that littleOnce you have located the igniter, you will need
wonder. This is how can it be changed?to find the screw or screws that hold the igniter
Changing the igniter on your gas furnace really isin place. Remove or in some cases just loosen
not all that hard. But it may require a bit ofthe screw and remove the igniter. Take careful
patience and some tools that can get into somenote of the location and position of the old igniter
very tight quarters. Some furnace manufacturersso that you can reinstall the new one in the exact
have design their units to make this job veryposition as the old one. In most cases the wiring
easy. Some other engineers obviously have neverwill just be a Molex plug that you can just unplug
got away from their desk and picked up a screwthe old igniter and then plug your new igniter back
driver. Hopefully you are lucky enough to haveinto it.
one of the easy ones.Carefully position the new igniter into the same
The higher the efficiency of your furnace thelocation and tighten the screw(s) that hold it in
harder this job will be. Usually the 90+ furnacesplace. Plug the new igniter into the plug and
will have the burner compartment sealed. You willreplace the covers on the burner compartment if
have to get the covers off of the burnerthere is one.
compartment to get to the igniter. On theNow you can turn the power back on to your
80%er's the igniter will usually be somewhere onfurnace and try for ignition. Hopefully you get the
the burner nearest the center of all the burners.glow and ultimately fire in from the burners. This
Make sure that you remove all power to yourwill give you heat and make everyone happy!