Water Heater Installation Guide

Installing a water heater is a common home repairsecurely to prevent leaking of gas. Maintain a
job. It is not a complex process and homeownersclearance space of 6 inches around the perimeter.
can do the installation themselves. However, it isAlso ensure that there are no inflammable
important to ascertain that there is no room formaterials in the vicinity.
errors. It is necessary to read the directions and4. Screw the inlet and outlet fittings with blue in
follow few simple guidelines to avoid adversethe cold water inlet and red in the hot water
results. Mentioned below are some steps that canoutlet. Also ensure that the arrowheads on the
help you to install water heaters perfectly.pipes point in the direction of the water flow.
Next, fix the third line to the main water supply
1. The first step of installing a new water heaterpipe.
is to detach the existing one. Before disconnecting5. Attach flexible connectors to the inlet and
the old unit, turn off the water, electricity or gasoutlet pipes. Install a shutoff valve to the cold
supply. If necessary, use a wrench to unscrewwater inlet. Turn on the relief valve that controls
the inlet and outlet fittings to remove hot water.the heat and air pressure generated in the water
For gas heaters, you have to detach the ventheater.
pipe that is connected to the draft hood. Also6. After completing all the connections, the final
remove the flue hat from the top of the heater.step is to connect the new water heater to the
2. Water heaters are heavy. Hence, it is advisablepower supply. Refer the manual to make correct
to use a dolly to avoid damages while moving theelectrical connections.
unit.7. Open the shutoff valve to fill water in the
3. Place your new unit in a way that is offersheater. While it is filling, open the hot water
easy access to the connecting pipes and controls.faucets to remove air from the pipes.
Make sure that gas water heaters are connected